Ekho - E-10

Current Heart Rate

ECG Accurate

Watch Functions:

Time of Day

Other:

Large Dual Display

Easy to Start

Water Resistant

Comfortable Ultra-Slim Ergonomic Chest

Belt Transmitter w/ user Changeable Batteries

Interfaces with Heart Rate Interactive Exercise

Equipment at home and in the gym

Mount the Receiver on either your left or right wrist.

The watch receives and translates the electrical

signals generated by your heart via the transmitter.

Transmitter Belt:

Attach the transmitter to the elastic strap.

Wrap the transmitter around your chest and adjust

the length of the strap so it fits snug.

The strap should be comfortable and secure.

(If the strap is not secure, the electrodes may lose

contact or the transmitter may slide down during

exercise.)

The transmitter should be positioned just below the

breasts/pectoral muscles, with the transmitter

centered on the chest.

Wet the electrodes (rubber pads), the

electrodes must be wet for accurate heart rate.

The transmitter will automatically turn on when the

above actions are done.

The optimal distance from the receiver (watch) to the

transmitter is 1 meter (3.28 feet).

Note:

3. Setting Time

Press “Select” and hold for 3 seconds. 12/24 hour will flash.

When 12/24 hour begins to flash, press “Select” to select

mode.

When finished wait 7 seconds and hours will begin to flash.

Press “Select” until hour desired is flashing. Wait 7 seconds.

Repeat this process with Minutes and Seconds.

Once complete wait 7 seconds and clock will begin.

4. Now It’s Time to Begin

Press “Select”, a zero will appear in the lower portion of the

Display. Once a signal from the transmitter is detected, the

heart symbol will begin to flash in conjunction with your

heartbeat. Your heart rate will display in a few seconds.

If the heart symbol does not flash, the signal is not being

received. Check the position of the transmitter. Verify the

electrodes are moistened.

5. Now It’s Time to Begin

Press “Mode”, until a zero will appear in the lower portion of

the Display. Once a signal from the transmitter is detected,

the heart symbol will begin to flash in conjunction with your

heartbeat. Your heart rate will display in a few seconds.

If the heart symbol does not flash, the signal is not being

received. Check the position of the transmitter. Verify the

electrodes are moistened.

6. Your done exercising.

Wash Transmitter belt with soapy water then rinse.

Dry Transmitter with soft cloth.

Store Transmitter a place that is clean and dry. Dirt and

moisture may cause transmitter to continue reading, reducing

the life of the battery.

7. Haven’t exercised in a while?

Ekho Heart Rate Monitors is to be used to display heart rate

during exercise only and cannot predict the intensity level that

is safe for you. It is not intended for medical diagnostic

purposes or for prevention of heart related health problems.

Before you begin any exercise program, please consult your

physician:

a. If you have been inactive for a period of time

b. Have a history of cardiac illness

c. Smoke

d. Have high blood pressure

e. Are over-weight.

If you use a pacemaker, do not use a heart monitor until you

consult your doctor.

8. Ekho Specifications

Receiver:

Heart Rate Range 30 to 240 BPM

Heart Rate Accuracy +/- 1 BPM

Operating Temperature 0 C-50 C (32 F – xx F)

Storage Temperature -20 C – 80 C (xxF-xxF)

Battery 3 volt Lithium 2032 cell

Weight 30.6 grams

Transmitter & Belt:

Emitted Frequency 5KHz +/- 10%

Battery 3 volt lithium 2032 cell

Weight 4 oz.

9. Limited Warranty

Warranty, Terms and Conditions

If the product becomes defective during the 2-year Limited

Warranty period Ekho will repair or

replace any defective component part at no charge to the

original owner, subject to the limitations

and requirements listed.

THE FOLLOWING IS REQUIRED BY EKHO when requesting

warranty services:

Check your resellers return policy. All purchased products

must be returned to original place of

purchase within their return policy time period.

The product must be packed in the original shipping carton or

in a suitable packing offering

similar degree of protection. To avoid scratches or other

damages to the product during shipping

separate items, such as HRM, transmitter belt, transmitter,

should be individually wrapped and

placed in the same package. This will reduce any extra cost of

return freight/postage. Please

include a copy of Proof of Purchase and/or copy of registration

form.

Limitations: The limited warranty provided by Ekho does not

cover: A: Batteries. B: Damages

due to misuse. C: Abuse or accidents. D: Cracked or broken

cases. E: Negligence of Precautions. F: Improper

maintenance or commercial use. D: Repairs made by a non-

Authorized technician. The warranties contained herein are

expressly in lieu of any other warranties including implied

warranty of merchantability and/or fitness for purpose. In no

event

Shall Ekho be liable for arising out of or related to the use of

this manual or the products

Described herein.

10. Disclaimer

The material in this manual is for informational purposes only.

The products it describes are subject to change without prior

notice, due to the manufacturer’s continuous development

program.

Ekho makes no representations or warranties with respect to

this manual or with respect to the products described herein.

Ekho shall not be liable for any damages, direct or incidental,

consequential or special, arising out of, or related to the use of

this material or the products described herein.

EKHO Brand Americas, LLC

1624 Harmon Place Suite 207

Minneapolis, Minnesota 55403

001-612-922-3766

001-612-922-3767

www.ekho.us